Scag Power Equipment TIGER CAT STC52V-24FX Operator's Manual Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
33
R
Section 7
FUEL LEVEL
FILLER NECK
INSERT
C.A.R.B. / EPA Phase 3 Fuel LevelFigure 7-6.
To avoid personal injury or property damage, use extreme
care in handling gasoline. Gasoline is extremely flammable
and the vapors are explosive.
Extinguish all cigarettes, cigars, pipes and other 1.
sources of ignition.
Use only an approved gasoline container.2.
Never remove the gas cap or add fuel with the 3.
engine running. Allow the engine to completely cool
before fueling.
Never fuel the machine indoors or in an enclosed 4.
trailer.
Never store the machine or fuel container where 5.
there is an open flame, spark or pilot light such as on
a water heater or other appliances.
Never fill containers inside a vehicle or on a truck 6.
or trailer bed with a plastic liner. Always place
containers on the ground away from your vehicle
before filling.
Remove the machine from the truck or trailer and 7.
fuel on the ground. If this is not possible, then refuel
the machine with a portable container, rather than
from a gasoline dispenser nozzle.
Keep the nozzle in contact with the rim of fuel tank 8.
or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
If fuel is spilled on clothing, change clothing 9.
immediately and wash affected skin.
Replace gas cap and tighten securely. For Low 10.
Emission (LE) and EPA Phase 3 (produced after
1/1/2011) models, tighten the fuel cap until it
ratchets.
B. REPLACING IN-LINE FUEL FILTER
ELEMENTS
The engine fuel filter should be replaced after every 500
hours of operation or annually, whichever occurs first.
Close the shut-off valve.1.
Remove and replace the engine fuel filter. Open the 2.
fuel shut-off valve.
ENGINE AIR CLEANER7.6
A. CLEANING AND/OR REPLACING AIR
CLEANER ELEMENT
For any air cleaner, the operating environment dictates
the air cleaner service periods. Inspect and clean the air
cleaner element after every 100 hours of operation or bi-
weekly, whichever occurs first and replace the element if
required.
- NOTE -
In extremely dusty conditions it may be necessary
to check the element once or twice daily to prevent
engine damage.
Release the two latches securing the air cleaner 1.
cover to the air cleaner assembly and remove the
cover. Set aside.
Remove the air cleaner and inspect.2.
Clean or replace the air cleaner and foam 3.
pre-cleaner as recommended by the engine
manufacturer.
Replace the air cleaner cover and be sure to snap 4.
the two latches closed.
Page view 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Comments to this Manuals

No comments