Scag Power Equipment GC-STC-CS User Manual

MODEL GC-STC-CSTHIS MANUAL CONTAINS THE OPERATINGINSTRUCTIONS AND SAFETY INFORMA-TION FOR YOUR SCAG ACCESSORY. READ-ING THIS MANUAL WILL PROVIDE YOUW

8GC-STC 48" & 52" BLOWER HOUSING ASSEMBLYWARNINGINSTALL BELT COVER BEFOREOPERATING MACHINEREAD OPERATOR'S MANUALROTATING BLADES AND

9GC-STC 48" & 52" BLOWER HOUSING ASSEMBLYRef. PartNo. Number Description1 04067-07 Pin, Ring 2-1/4" Long2 481547 Lanyard

10GC-STC 48" & 52" BLOWER MOUNTING COMPONENTS123456678910101112131415151617181920390STC203A21226RIGHT SIDE OFCUTTER DECK SHOWN

11GC-STC 48" & 52" BLOWER MOUNTING COMPONENTSRef. PartNo. Number Description1 482612 Belt Cover, GC-STC2 04029-04 Wingnut, Plastic 3/8 S

12GC-STC-CS HOPPER COMPONENTSAABBCCCSHOPPEREXPLOD-STC-1 11645151445435655617415054349315111405859251289344950 2434294227483853103361603719362049332157

13GC-STC-CS HOPPER COMPONENTSRef. PartNo. Number Description1 461627 Hopper, GC-STC-CS2 482732 Door, GC-CS3 461626 Sweeper Weldment, GC-CS4 48

14GC-STC DECALS481039482275482733482293

LIMITED WARRANTY- COMMERCIAL ACCESSORYAny part of the Scag commercial accessory manufactured by Scag and found, in the reasonable judgment of Scag,to

PART NO. 03139PRINTED 8-2003PRINTED IN USA© 2003SCAG POWER EQUIPMENTDIVISION OF METALCRAFT OF MAYVILLE, INCwww.scag.com

FAILURE TO FOLLOW SAFE OPERATING PRACTICES MAY RESULT IN SERIOUS INJURY.* Keep all safety shields in place.* Before performing any maintenance or se

11.1 INTRODUCTIONThis manual has been prepared to provide theinformation you need to correctly assemble, operate,and maintain this grass catcher. Read

23. When dumping the hopper into a disposal area:A. Disengage the deck drive, apply the parkingbrake and allow all moving parts to come toa complete s

33.1 ASSEMBLY INSTRUCTIONS FOR 48" AND 52" CUTTER DECK-NOTE-Use the illustrated parts list as a part numberreference when following th

4PROPERLYSERVICEENGINEWITHOILANDFUEL.FIGURE 3-3FIGURE 3-4DISCHARGE CHUTE OPENINGFRONT OF CUTTER DECKREAR OF CUTTER DECKVIEW FROM RIGHT SIDE OF CUTTER

58. Align the blower assembly with the dischargeopening of the cutter deck. Tighten the hardwarefor the mounting bracket. Then tighten thehardware for

61. Prepare the work area making sure that it is aclean, safe environment.2. Remove the rubber strap holding the adapter tothe blower assembly. See Fi

7Notes